I believe that many customers don’t understand the machine after buying the steel bar straightening machine, and don’t know how to operate it. Here I will give you a detailed introduction to the operation process of the steel bar straightening machine.

Steel bar straightening machine use steps：

First of all, the material rack and trough of the steel bar straightening machine should be installed straight, and should be aligned with the center line of the guide tube, straightening tube and the lower cutter hole, use the hand to turn the flywheel, check the transmission mechanism and working device, and adjust the gap.Tighten the bolts, confirm that it is normal, start dry running, and check that there is no abnormal noise in the bearings, the gears are in good meshing, and the operation is normal.

Secondly, the appropriate straightening block and transmission speed should be selected according to the diameter of the straightening steel bar. The diameter of the straightening block should be 2~5mm larger than the steel bar diameter. The transmission speed should be selected according to the steel bar diameter. The material can be fed only after the commissioning is qualified.Remember that the straightening machine is not fixed and the protective cover is not covered. It is strictly forbidden to open the protective cover to adjust the gap during work. When the steel bar is fed in, keep a certain distance between the hand and the traction wheel and do not approach it. Again, before feeding, the non-straight ends of the steel bars should be cut off.A 1m long steel pipe should be installed in front of the guide tube. The steel bar should pass through the steel pipe and then be fed into the guide hole at the front end of the straightening. If the straightened steel still bends slowly, you can gradually increase the offset of the straightening block , Until straightening, after cutting 3 to 4 steel bars, the machine should be stopped to check the length, when the allowable deviation is exceeded, the limit switch or the fixed-length plate should be adjusted.

Finally, you can start to use the steel bar straightening machine, because the steel bar straightening machine adjusts the steel bar fast, and the work efficiency is high. You must pay attention to safety during use.

Regarding the above detailed introduction about the operation process of the straightening machine, I believe that even users who do not know the machine can make the machine work normally. Correct operation of the machine can not only ensure the safety of the operators, but also increase the service life of the machine !