Safety operation rules of CNC steel cage winding machine I

Before using the CNC steel cage winding machine, the following inspections are required for the equipment:

1. Check whether all stop buttons are in the pressed state, and whether the control power switch is in the off state;

2. Whether the connection of each line of the CNC steel cage winding machine is normal, and whether the encoder connection cable on the fixed plate of the mobile disk is normal;

3. Whether there is oil leakage;

4. Whether the bolts and nuts are loose;

5. Whether too much dust in the electric control cabinet affects normal production;

6. Whether the hydraulic oil station enters the water;

Safety operation rules for CNC steel cage winding machine II

1. During the operation of the equipment, pay attention to avoid the phenomenon of motor overheating;

2. During operation, the electrical parts cannot be covered, and the heat dissipation of the CNC steel cage winding machine must be kept smooth;

3. After one to two months of normal operation of the equipment, the circuit breaker, motor wiring terminals, and wiring terminals in the electrical box should be tightened one by one when the power supply is cut off;

4. After one to two months of normal operation of the equipment, the oil quantity of the reducer and the hydraulic station should be checked. If there is a problem of insufficient or too dirty, it is necessary to add or replace the hydraulic oil;

5. All lubricating oil nozzles need to be greased once a week. If the grease at the nozzle is not good, it needs to be removed and replaced with new oil;

6. Use a brush or a breeze blower to remove the dust in the electric control cabinet regularly every week;

7. Equipment operators need to be trained before they can operate the equipment;

8. It is strictly forbidden to use a damp cloth or a damp brush to clean or brush the dust in the electrical cabinet.