You must be familiar with the machine operation before starting the tube straightening machine.
Before opening the tube straightening machine for adjustment or testing, the power must be turned off, and live operation is strictly prohibited.
During production, it is strictly forbidden to have people within 3 meters from the feeding mechanism to the two sides of the feeding port, in order to prevent the steel bar from popping out and hurting people.
Special personnel are required to take care of the tube straightening machine during operation. If there is any abnormality, it must be immediately shut down and powered off.
The numerical control instrument is dust-proof, moisture-proof, rain-proof, imitating high temperature and direct sunlight.
Protect the wires, prohibit water immersion and rolling.
The trolley guide rail is filled with lubricating oil once a day.
Do not use for a long time, or turn off the power of the straightener when there is thunder and lightning.
Check the oil level of hydraulic oil frequently, it is less necessary to submerge the filter 3-4cm, pay attention to keep the hydraulic oil clean, and replace it every 6-12 months.
First of all, it should be placed in a dry room, and avoid placing it in a humid environment to avoid the influence of the line of the rebar bending machine. If it must be placed outdoors, then we need to put it on a flat ground and cover it with a cloth to prevent the rebar bending machine from getting wet.
The mechanical fuel control lever should be placed in the idle position. If it is not adjusted to the idle position, it will cause unnecessary damage to the engine. Each lever should be placed in the neutral position.
If it needs to be stored for a long time, it must be maintained before it is not used. If the parts are damaged, they need to be replaced, which will prolong the life of the machine.
The above is the code of use for the tube straightening machine and the main points of machine maintenance that I have compiled. I hope it will be helpful to everyone.