1.Precautions for the use of Vibratory plate compactor
- Add gasoline to the fuel tank of Vibratory plate compactor,and the gasoline drum must be clean. There should be no sand, debris, water, or other oil in the fuel tank.
- Oil shall not deteriorate, such as water, oil aging for a long time to use, timely replacement of problems.
- When starting the engine of Vibratory plate compactor to pull the drawstring, do not use excessive force, as long as you feel the resistance in the pull, and then pull it hard at this position, it will start; then gently send the start pull handle back.Winter start can be a semi-opening damper to increase the concentration of gasoline and air to facilitate start-up, must be turned on after starting
- After the engine is started, do not open the throttle too much, open 80%, because the engine is easy to damage due to long working temperatures.
- Do not used Vibratory plate compactor in the ground on hard ground and already working surfaces. Hard to hard will cause damage to the implement.
- The lime soil working surface is sturdy before the water is sprayed, and the surface is not stuck to the tamping, and the tamping effect is achieved.
- When working on a cement concrete surface or stable layer, the appearance of the Vibratory plate compactor must be cleaned after use, and the cleaning will not be cleaned after solidification to affect the appearance.
2.How to detect that the Vibratory plate compactor does not work
- Check the amount of fuel in the tank.
- Check if the fuel tank switch of Vibratory plate compactor is in the open position.
- Check the amount of oil.
- Check that the air filter element of Vibratory plate compactor is clean.
- Check that the throttle handle of Vibratory plate compactor is open to the large throttle position.
- Check if the flameout power switch of Vibratory plate compactor is off.
- Check if the spark plug high voltage line of Vibratory plate compactor is plugged in.
- Remove the spark plug to check if the gasoline in the cylinder has passed, and pull the starting rope to idle to remove excess gasoline.
- Replace the spark plug ( remove with a special sleeve).
- Check if the fuel filter at the lower end of the fuel tank switch has dirt and oil.
- Still can’t start the internal engine problem.
