How to install a tmt bar straightening machine safely?
- The centerline of the material trough of the pressure-bearing frame must face the centerline of the guide cylinder, the straight cylinder and the lower cutter hole when the pressure-bearing frame is installed.
- First of all, check whether the electrical system and other components are damaged, whether the connecting parts of the tmt bar straightening machine are firm and reliable, and whether the transmission parts are flexible.
need to check. All components have been confirmed to function properly before commissioning. During the test run, check whether the hammer head, bearing temperature, blade and shear gear are normal. when correct
When there is no abnormal situation, feeding, test adjustment and cutting can be carried out.
- Tmt bar straightening machine the diameter of the steel bar as required, and select the appropriate straightening block, wheel groove and transmission speed. The diameter of the adjustment block should be larger than the diameter of the steel bar by 2mm~5mm, and the pulley groove should be。The width should be consistent with the diameter of the steel bar required to be adjusted.
- Care must be taken to adjust the adjustment module. In the tmt bar straightening machine, there are generally 5 straightening blocks, 1 and 5 straightening blocks must be placed on the centering, and 3 straightening blocks can be away from the centering. steel first
Move the bar to 3mm, and then try to adjust the right angle. If the bar is still bent slowly, you can gradually increase the right angle until the right angle is adjusted.
- At the front of the conduit, a 1-meter-long conduit pipe should be installed. The steel bars required to be straightened should first pass through the steel pipe, and then into the guide cylinder and the straightening cylinder to prevent the steel bars from being connected to each other.
Injury due to the close adjustment of the straight and the steel head popping out.
- Before the tmt bar straightening machine block is fixed and the protective cover is not covered, do not penetrate into the steel bar, so as to avoid the straightening block flying out after starting the tmt bar straightening machine and causing injury.
