After using the steel bar straightening machine, the floor of the machine and the work surface should be cleaned, so that the steel bar straightening machine will not be stored due to the accumulated impurities in the next use process.

quality and the machine deviation is too large. Let’s take a look at the method of repairing the steel bar straightening machine.

(1) Before working, carefully check the firmness of each joint and the lubrication of each relative moving part. Other objects and tools are not allowed to be placed on the machine.

(2) Daily maintenance should be done in each shift.

(3) The installation of the straightening die in the straightening cylinder should be checked regularly, and the scale and rust accumulated in the planes on both sides should be removed.

(4) Pay attention to the working conditions of the machine and the bearing temperature at any time during the operation. When the temperature reaches above 60°C, stop the machine in time, find out the cause and eliminate it before continuing to use it.

(5) The handover should be carried out under the condition that the machine is running normally and clean. Before leaving get off work, each shift should arrange the steel bars, wipe the machinery clean, and fill in the handover diary.

(6) The straightening machine should be lubricated according to the specified lubrication parts and lubrication cycle, and its lubrication requirements and grease (oil).

(7) The straightening machine should be maintained at the first level after every 700 hours of use, and the maintenance should be carried out in accordance with the regulations.

The first step in the repair process is to disassemble the straightener, clean the parts, and inspect each part for damage. The second is to check whether the center bearing and gear are misaligned

Leave. The last is the maintenance of mechanical parts of the steel bar straightening machine, which includes checking whether the small parts such as the belts and bolts inside the steel bar straightening machine can work normally. Check work base for each step

This is inseparable from the cleaning of the machine, so the most critical and basic method in the process of machine maintenance is to take cleaning as the premise.

During the maintenance process of the steel bar straightening machine, the gear oil should be poured into a clean bucket to allow it to settle. After the repair, it can be injected into the oil tank for reuse. After repairs are completed, where necessary

Apply lubricating oil and anti-rust oil beforehand. It is best to paint the work surface to prevent dust from entering the inside of the machine.