To use the rebar straightening machine correctly,

In order to further improve the work efficiency, you can pay attention to the following points during the operation:

1. Adjust the straightening block. There are five straightening blocks in the general straightening cylinder. The two straightening blocks yi and 5 must be placed on the center line, and the three middle ones can be deviated from the center line. First make the steel bar offset by about 3mm

After adjustment, if the steel bar still bends slowly, gradually increase the offset until it is straightened.

2. After cutting three or four steel bars, stop the rebar straightening machine to check whether the length is suitable. If there is any deviation, adjust the limit switch or the fixed-length plate until it is suitable.

3. A steel bar of about 1 meter should be installed at the front of the guide tube of the rebar straightening machine. The straightened steel bars should pass through the steel pipes first, and then into the guide cylinder and the straightening cylinder to prevent each plate of steel bars from being nearly straightened.

When finished, it pops up to hurt people.

The information we provide for you is guaranteed to be professional and convenient for you to see and use. The company has been operating under the standard of customer first for many years. We will continue to provide you with information in the “News” column.

For more detailed product related, to ensure customer satisfaction.